Hellwig Helper Spring Kit, Load Pro Series ™ 35, Leaf Spring Design, Rear Upper, 3500 Pound Load Capacity, Steel – 3510
$442.54
Hellwig Helper Spring Kit, Load Pro Series ™ 35, Leaf Spring Design – 3510
Description
Helper Spring Kit; Load Pro Series ™ 35; Leaf Spring Design; Rear Upper; 3500 Pound Load Capacity; Steel; Requires Mount (See Required Parts); With Springs Only
Attributes:
- Type: Leaf Spring
- Load Capacity: 3500 Pound
- With Air Compressor: No
- Color: Black
- Quantity: Set Of 2
- Pressure Range: Not Applicable
- Material: Steel
- Mounting Type: Axle Mount
- With Bellows: No
- With Air Line: No
- With Roll Plate: No
- With Valve: No
- Remote Type: Not Applicable
- With Mounting Hardware: No
- Estimated Install Time (Hours): 1
Features & Benefits:
- Manufactured With Heat Treated Astm 5150 Alloy Spring Steel Increased Spring Rate And Stability
- Progressive Rate Design Is Fully Adjustable By Tightening Or Loosening The U-bolt
- Never Needs Adjusting
- Load And Sway Control In One Spring
- Simple Bolt-on Design Using Common Hand Tools Provide The Installer Ease Of Installation And The Vehicle Owner Hassle Free Use
- Limited Lifetime Warranty
About Product:
This Hellwig Helper Spring Set The Standard For All Other Aftermarket Helper Springs. Featuring Progressive Spring Rate And Fulltime Spring Rate Design, This Spring Is The Workhorse Of The Hellwig Spring Line. With The Progressive Design The Vehicle Must Be Loaded And Its Spring Compressed To Activate The Hellwig Spring, Therefore As The Vehicles Load Increases The Hellwig Helper Spring Progressively Increases Its Resistance To The Load. In The Fulltime Design The Hellwig Spring Immediately Reacts To The Vehicles Load, Therefore Compressing Very Little As Load Is Applied To The Vehicle. Manufactured With Heat Treated Astm 5160 Alloy Spring Steel These Units Increase Your Vehicles Level Load Carrying Capacity Up To The Manufacturer’s Gross Vehicle Weight Rating. Designed To Install On Full Size Pick-up Trucks And Vans, This Unit Requires Mounting Hardware To Accommodate 2-1/2 Inch Or 3 Inch Wide Leaf Springs. Simple Bolt-on Design Using Common Hand Tools Provide The Installer Ease Of Installation And The Vehicle Owner Hassle Free Use.
Additional information
| Weight | 58 lbs |
|---|---|
| Dimensions | 45 × 8 × 3 in |
| Brand | HELLWIG |
| Manufacturer Part Number | 3510 |
Vehicle Fitment
This part fits the vehicles listed below. Always confirm fitment for your exact vehicle before ordering.
This part is compatible with 21,269 vehicles.
| Year | Make | Model | Trim | Engine | Notes |
|---|---|---|---|---|---|
| Loading fitment... | |||||
Related products
-
Crown Automotive Tie Rod End, Greasable, With Offset, Steel – 52060052AF
Vehicle-Specific Part: Check Fitment $154.95 Add to cart Quick View -
Crown Automotive Steering Shaft, Lower – 52078705
Vehicle-Specific Part: Check Fitment $285.19 Add to cart Quick View -
Crown Automotive Wheel Bearing Hub Assembly Bolt – 34201535
Vehicle-Specific Part: Check Fitment $7.35 Add to cart Quick View -
Crown Automotive Coil Spring Isolator, Black, Rubber, Single – 52059912AC
Vehicle-Specific Part: Check Fitment $19.00 Add to cart Quick View