Holley Distributor, Holley Sniper Efi, For Use with Holley Efi Systems, With Ignition Control Module, Crank Trigger – 565-300K
$1,243.69
Holley Distributor, Holley Sniper Efi – 565-300K
Description
Distributor; Holley Sniper EFI; For Use With Holley EFI Systems; With Ignition Control Module; Crank Trigger; Distributor/ Coil/ Ignition Box/ Integrated Sniper EFI Harness
Attributes:
- Condition: New
- Finish: Polished Shaft
- Recommended Use: Chevrolet Small Block/ Big Block Engines
- Spark Advance Type: Computer Controlled Advance
- Spark Distribution Type: Hall Effect
- Drive Gear Type: Cast Gear
- With Ignition Module: Yes
- With Tach Drive: No
- Includes Cap And Rotor: Yes
- Cap Color: Black
- Cap Type: HEI/ Male Posts
- Coil In Cap: Yes
Features & Benefits:
- HyperSpark Distributors Feature A Hall Effect Crank Trigger Sensor Providing A Noise-Free RPM Signal To The Sniper ECU
- Patented Clear Installation Cap Eliminates Any Confusion While Installing The Distributor
- HyperSpark CD Ignition Box Is Seal And Powder Coated To Be Installed In The Harshest Of Locations
- External LED On Hyperspark CD Ignition Box Helps Verify 12 Volt, Cranking RPM And Low Battery Voltage
- Integrated Ignition Coil Bracket Simplifies Mounting The Ignition Coil
- Ignition Coil Connector Removes Any Doubt Of Loose Connections At The Ignition Coil
- Enables Timing Control On A Sniper EFI Installation
- Limited Supplier Warranty
About Product:
Our HyperSpark Master Kits were designed to make upgrading your ignition on a Sniper EFI-equipped engine simple. When installed concurrently with a new Sniper EFI system, the combination creates the easiest to install EFI conversion on the market – only four flying lead connections required. This harness only requires one connection to a switched power source, battery positive, battery negative and fuel pump power. The pre-terminated connectors and a built in 40 Amp relay provides power to all of the components within the system. With the included Sniper EFI Main Harness you no longer need to run multiple wires to provide switched power for each individual component. This not only helps prevent wiring confusion, it will speed up your install time and clean up your engine bay. Just route the harness and pre-terminated connectors to your HyperSpark coil, distributor and ignition box and plug them in.
Additional information
| Weight | 10.45 lbs |
|---|---|
| Dimensions | 17.4 × 11.8 × 9.2 in |
| Brand | HOLLEY |
| Manufacturer Part Number | 565-300K |
Vehicle Fitment
This part fits the vehicles listed below. Always confirm fitment for your exact vehicle before ordering.
This part is compatible with 15,547 vehicles.
| Year | Make | Model | Trim | Engine |
|---|---|---|---|---|
| Loading fitment... | ||||
Related products
-
Crown Automotive Motor Mount, Engine Mount, Bolt on, Not Adjustable, Black, Steel, With Transmission Mount – 52058928K
Vehicle-Specific Part: Check Fitment $226.19 Add to cart Quick View -
Crown Automotive Thermostat, With Housing – 5175583AB
Vehicle-Specific Part: Check Fitment $73.94 Add to cart Quick View -
Crown Automotive Caliper Piston, With Piston/ Seal/ Boot – 68003882AA
Not sure it fits? Ask us $21.78 Add to cart Quick View
